Tru Design Ball Valves are designed and made in New Zealand for use in marine applications above and below the water line. They are IMCI & Bureau Veritas approved to ISO standard 9093-2 and are ideal for controlling inlet and outlet water requirements.
The bodies of these valves are moulded in a glass reinforced nylon composite material providing high impact and tensile strength, resulting in a light weight unit, free from corrosion and electrolysis. The internal workings are moulded in a Teflon enhanced polymer for a smooth action, also ensuring continuous ease of operation over many years.
Please note that the handle can be easily removed from all size ball valves if required during instillation by removing the cap which is the same colour as the handle and is next to the Tru-Design logo. Use a sharp knife to flick it out then unscrew the stainless screw with a philips screwdriver. Make sure the handle is replaced after instillation.
Manufactured from a glass reinforced nylon composite - High strength and light weight
Immune to corrosion and electrolysis - Long life with no concerns over decreased performance due to corrosion
Chemical resistant - Impervious to diesel, petrol and antifouling paints
UV resistant - Will not break down with ultraviolet light or discolour from the sun
Large operating temperature range (-20° to 80°C)
High quality surface finish - Will not discolour with green film as similar bronze fittings do
Standards approved through IMCI & Bureau Veritas to ISO standard 9093-2
Please select the thread size from the list below
This product was added to our catalog on Sunday 16 September, 2007.